Mouthpiece Work / Glass Gauge and feelers set sources?
FROM: gianniveloce (Gianni Veloce)
SUBJECT: Glass Gauge and feelers set sources?
hi everyone,
do you know any existing procurement sources  for glass gauge and feeler set in Europe?
If not, what are these sources in US and what about the prices?

Thank you 

GV
FROM: lancelotburt (MartinMods)
SUBJECT: Re: Glass Gauge and feelers set sources?
After breaking a few commercial glass gauges, I use a printed template attached to a piece of plate glass.


On Tuesday, May 13, 2014 11:56 AM, "Gianni Veloce gianniveloce@... [MouthpieceWork]" <MouthpieceWork@yahoogroups.com> wrote:
 
  
hi everyone,
do you know any existing procurement sources  for glass gauge and feeler set in Europe?
If not, what are these sources in US and what about the prices?

Thank you 

GV
FROM: gianniveloce (Gianni Veloce)
SUBJECT: Re: Glass Gauge and feelers set sources?
Super Fast answer! Thanks!
Could you pls describe how exactly you printed it (on transparency ?) and how you mounted on the glass.
Btw what is "plate" glass? (sorry not a native english speaker here).

thx
GV


On Tuesday, May 13, 2014 10:04 PM, "MartinMods lancelotburt@... [MouthpieceWork]" <MouthpieceWork@yahoogroups.com> wrote:
 
  
After breaking a few commercial glass gauges, I use a printed template attached to a piece of plate glass.


On Tuesday, May 13, 2014 11:56 AM, "Gianni Veloce gianniveloce@yahoo.com [MouthpieceWork]" <MouthpieceWork@yahoogroups.com> wrote:
 
  
hi everyone,
do you know any existing procurement sources  for glass gauge and feeler set in Europe?
If not, what are these sources in US and what about the prices?

Thank you 

GV
FROM: lancelotburt (MartinMods)
SUBJECT: Re: Glass Gauge and feelers set sources?
Plate glass is a bit thicker than normal window/slide glass.  I cut it to size, ground down the edges, and stuck the high-res printed transparency (transparent label) and covered it with a layer of clear tape.


On Tuesday, May 13, 2014 12:40 PM, "Gianni Veloce gianniveloce@... [MouthpieceWork]" <MouthpieceWork@yahoogroups.com> wrote:
 
  
Super Fast answer! Thanks!
Could you pls describe how exactly you printed it (on transparency ?) and how you mounted on the glass.
Btw what is "plate" glass? (sorry not a native english speaker here).

thx
GV


On Tuesday, May 13, 2014 10:04 PM, "MartinMods lancelotburt@... [MouthpieceWork]" <MouthpieceWork@yahoogroups.com> wrote:
 
  
After breaking a few commercial glass gauges, I use a printed template attached to a piece of plate glass.


On Tuesday, May 13, 2014 11:56 AM, "Gianni Veloce gianniveloce@... [MouthpieceWork]" <MouthpieceWork@yahoogroups.com> wrote:
 
  
hi everyone,
do you know any existing procurement sources  for glass gauge and feeler set in Europe?
If not, what are these sources in US and what about the prices?

Thank you 

GV