Alf,
 
Where did you have it plated?
 
Thanks,
Pete

-----Original Message-----
From: Alf Reid (AST VDB) [mailto:alf.reid@...]
Sent: Thursday, October 09, 2003 2:54 AM
To: MouthpieceWork@yahoogroups.com
Subject: RE: [MouthpieceWork] Fixing L.A. Sax silver pated soprano mouthpiece


        The deep machining marks across the table and rails reminds me about the worst mouthpiece I have ever seen,
        a Wolfe Tayne baritone mouthpiece.  This mouthpiece also had a very short facing meeting the table
        with a sharp angle.  I had to remove a lot off metal to remove the machining marks. Afterwards I had it plated in silver,
        20 microns thick , at a lower than normal current density which leaves a harder layer of silver to last longer.